Supacolor Headwear Custom Transfers Application Instructions

1. Set Temperature and Time
- Polyester 290F (140C)
- Cotton 320F (160C)
- 10 seconds

2. Load a Test Hat
Fold back headband and spend time to make sure hat fully conforms to the platen (use the smallest platen that works).

3. Set Pressure
- Manual Press: Tighten dial until the press won’t close. Loosen dial progressively until the press closes.
- Hotronix Hat Press: 8-9

4. Pre Press 3 Seconds
Pre press 3 seconds to flatten out. Check if hat is flat against the platen. If not, creases will show and you will not get a good result. It needs to be flat!

5. Place Supacolor
Position the transfer on the garment. Lay teflon sheet or parchment paper over the Supacolor.

6. Press 8-12 Seconds

7. Peel Immediately
Hot peel immediately from a corner in one smooth motion. Peel with confidence and without hesitation.

8. Post-Press: 2-4 Seconds
Use a teflon sheet or parchment to seal the edges of the Supacolor.