Supacolor SupaReflective on Cotton & Blends Application Instructions

1. Set Temperature and Time

• 290°F - 320°F
• 12-15 seconds

2. Load a Test Garment

If possible, slip the platen through the shirt so there is only one layer of fabric op top. This will improve contact and speed things up! Otherwise, lay the tee on top of the platen.

3. Set Pressure

• Manual Press: Tighten dial until the press won’t close. Loosen dial progressively until the press closes.
• Hotronix and Geo Knight: 8-9
• Pneumatic Press: 40-50 PSI

4. Pre-Press: 5-8 Seconds

Prepressing releases moisture from the garment ensuring good contact. Repeat this step until there is no steam.

5. Place SupaReflective Transfer

Position your SupaReflective transfer on the garment. Lay the teflon sheet or parchment paper over the SupaReflective

6. Press 12-15 Seconds

7. Cold Peel

Wait a few minutes for your SupaReflective transfer to cool down before peeling.

8. Post-Press: 2-4 Seconds

Use a Non-stick sheet or parchment to seal the edges of the SupaReflective.