Texprint Sublimation Paper on 20oz Skinny Tumbler with a 3D Vacuum Heat Press
Application Instructions
- Turn the 3D Vacuum Heat press on.
- Set the heating button so both the top and bottom heating lights are on. (2 red lights will be showing)
- Set the Temperature to 338 degrees F (170 degrees C) and time to 360 seconds (6 minutes).
- Print a mirror image onto Texprint Paper.
- Trim the edges of the image and wrap around the tumbler.
- Attach the image to tumbler using transfer release tape.
- Wrap tumbler with the skinny tumbler wrap.
- Place the tumbler on its side within the press.
- Press vacuum button
- Press the time button
- Remove immediately once finished and peel hot. Use caution as the tumbler will be very hot.