Supacolor Wearable Custom Transfers For Cotton Application Instructions

1. Set Temperature and Time

• 290F-320F (160C)
• 10-15 seconds

2. Load a Test T-shirt

If possible, slip the platen through the shirt so there is only one layer of fabric on top. This will improve contact and speed things up! Otherwise, lay the tee on top of the platen.

3. Set Pressure

• Manual Press: Heavy pressure. Tighten dial until the press won’t close. Loosen dial progressively until the press closes.

4. Pre-Press: 5-10 Seconds • Thicker Garments 15 Seconds

Prepressing releases moisture from the garment ensuring good contact. Repeat this step until there is no steam.

5. Place Supacolor

Place Supacolor transfer on the garment.

6. Press 10-15 Seconds

7. Peel Immediately

Hot peel immediately from a corner in one smooth motion. Peel with confidence and without hesitation. Hold down tee with your free hand for better control.

8. Post-Press: 8 Seconds

Use a Non-stick sheet or parchment to seal the edges of the Supacolor.