Supacolor Wearable Custom Transfers For Fleece Application Instructions
1. Set Temperature and Time
- 290F-320F (160C)
- 10-15 seconds
2. Load a Test Fleece
If possible, slip the platen through the shirt so there is only one layer of fabric on top. Otherwise, lay shirt on top of the platen. Avoid pockets if possible.
3. Set Pressure
- Manual Press: Heavy pressure. Tighten dial until the press won’t close. Loosen dial progressively until the press closes.
4. Pre-Press: 5-10 Seconds • Thicker Garments 15 Seconds
Prepressing releases moisture from the garment ensuring good contact. Repeat this step until there is no steam.
5. Place Supacolor
Position the transfer on the garment. Lay Non-stick sheet or parchment paper over the Supacolor. Keep print away from pockets and collar.
6. Press 10-15 Seconds
7. Peel Immediately
Hot peel immediately from a corner in one smooth motion. Peel with confidence and without hesitation. Hold down garment with your free hand for better control.
8. Post-Press: 8 Seconds
Use a Non-stick sheet or parchment to seal the edges of the Supacolor.